Furnace Craft Co logo Furnace Craft Co

Furnace Repair

Commercial Furnace Repair in Chicago, IL

Commercial furnace repair for small Northwest Side businesses: shops, offices and mixed-use buildings with gas furnaces or unit heaters.

  • ✓Owner-operated
  • ✓Shop on W Irving Park Rd
  • ✓Gas and electric furnaces

Quick answer: we repair furnaces and gas unit heaters in small commercial spaces such as storefronts, offices and mixed-use buildings. Call (773) 514 3683, tell us the equipment type, where it is in the building and what it does, and we tell you whether it is a job for us before we come out.

What we repair

Small commercial heat is often a gas furnace in a back room or basement, or a suspended unit heater in a shop. The faults are the same families as residential: ignition, flame sensing, blower, venting and controls. We work on small equipment common to storefronts and mixed-use buildings along the Irving Park Road corridor.

Symptom, likely cause, first check

Unit heater will not light: igniter or pilot, gas supply or a tripped safety switch. Furnace runs but space stays cold: filter, blower or an undersized unit. Heat then shuts off: overheating, flame sensor or venting. Check the thermostat or control, the unit's power switch and the filter.

What to tell us on the phone

The brand and model if you can read the data plate, the age, whether the thermostat or control calls for heat, what happens next and where the unit sits (basement, back room, mounted overhead). For a unit heater, tell us how it is mounted and whether it has a separate vent.

Mixed-use and landlord buildings

ZIP 60634 has many two-flats and small multi-unit buildings: about 11% of its housing units are two-unit buildings and 7% have three or four units (ACS 2020-2024). Owners of those buildings often manage the heating for tenants, so a no-heat call needs a quick call to us. Tell us how many units depend on the furnace and whether anyone is waiting in the cold.

Safety

If you smell gas, leave the building and call Peoples Gas at 866-556-6002. For carbon monoxide, leave and call 911.

What we do not do

This page covers small furnaces and unit heaters. If your equipment is outside what we repair, we will tell you on the call.

Technician insight

In Chicago 60634 the thing that catches most people out with Commercial Furnace Repair is how many small retail buildings still run 1980s rooftop units that were never properly maintained after the original tenant left. Cold winter wind across flat roofs accelerates heat loss and makes marginal exchangers fail fast once temperatures stay below freezing for more than a few days.

Rooftop Unit Failure at Portage Park Retail Strip

A small retail space near 6947 W Irving Park Rd lost heat during a January cold snap. Inspection showed a cracked heat exchanger on the aging rooftop unit and restricted airflow from a collapsed duct section added during a prior tenant build-out. The exchanger was replaced, the duct repaired, and the system was balanced so the single tenant space received consistent heat without affecting neighboring suites.

Commercial Furnace Repair Services We Offer

✓Unit Heater Repair

Ignition, thermostat and venting faults on small gas unit heaters.

✓Small Commercial Furnace Repair

Blower, ignition and control repairs on furnaces serving shops and offices.

✓Landlord Building Heat Calls

Furnace repair for two-flats and small multi-unit buildings, per unit.

Commercial Furnace Repair Cost in Chicago 60634, IL

Service Typical Range What Affects It
Commercial Furnace Diagnostic $175–$325 Higher for rooftop access or after-hours calls
Blower Motor Replacement $450–$950 Depends on motor horsepower and whether belts or pulleys are required
Heat Exchanger Assessment $250–$400 Includes panel removal and visual inspection
Gas Valve Replacement $300–$650 Varies by valve type and piping modifications needed

Ranges are typical for Chicago 60634, IL and confirmed with an exact written quote before any work starts.

How it works

  1. 1

    Call and describe

    Tell us the equipment, its location in the building and what it does.

  2. 2

    Site inspection

    We inspect the unit, controls and venting.

  3. 3

    Written quote

    You get a written quote before parts are replaced.

  4. 4

    Repair and test

    We test the unit through a complete heating cycle.

Pricing

We give a written quote after on-site inspection; the price depends on unit size and parts needed.

Furnace Craft Co — Furnace Repair in Chicago 60634

Good to know

Commercial Furnace Repair — FAQs

Still have questions? We're happy to talk it through.

(773) 514 3683
+ Do you repair rooftop units or boilers?
This page covers small furnaces and unit heaters. Call and describe your equipment and we will tell you if we can handle it.
+ Can you work around business hours?
Tell us your hours when you call and we will discuss scheduling.
+ Do you repair furnaces in two-flat rental buildings?
Yes, for buildings with furnace-based heat. Call and describe the system.
+ What information speeds up a commercial call?
Brand, model, age, location in the building, how it is vented and what it does when it calls for heat.

Furnace stopped working? Call us now

Call Furnace Craft Co and describe the problem. Satisfaction guaranteed on all furnace repair and maintenance work performed.

Call now Get help